New products
New products
-
![Bracket kit]()
Bracket kit
€69.00 -
![Shift Light Module]()
Shift Light Module
€200.00 -
![MyChron Steering Wheel]()
MyChron Steering Wheel
€200.00
Temperature Sensors
A complete range of temperature sensors dedicated to cars, motorbikes and karts.
-
CHT - Cylinder Head Thermocouple Binder
€85.00AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with
different diameters with a binder 3 pins connector with a 40 cm cable length.
-
![]()
EGT - Exhaust gas K type thermocouple
€85.00AiM devices can measure exhaust gas temperature using a sensor – thermocouple – placed in the exhaust header pipe. All AiM thermocouples are K type sensor and fit car/bike/kart installations.
The version with T12 connector is CIK-FIA homologated dedicated to karting.
Place the exhaust gas temperature sensor (EGT) in the header pipe at about 150 mm (5.9 inches) from the exhaust pipe. Cable lenght 40 cm.
-
CHT - Cylinder Head Thermocouple Mignon
€85.00AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with
different diameters and a mignon connector with a 40 cm cable length.
-
![]()
MyChron6 sensor patch cable
€46.00The patch cable designed for MyChron6 allow the connections of different sensors.
It is available in two versions for using with thermocouples and thermoresistors.
Cable length is 150 cm, may vary depending on the connector.
-
![]()
MyChron6 2T sensor split patch cable
€58.00The split patch cable designed for MyChron6 2T grant the use of two different sensor simultaneously.
It is available in three versions for using with thermocouples, thermoresistors or both.
Cable length is 150 cm, may vary depending on the connector.
-
![]()
M10 water temperature thermocouple
€85.00AiM devices can measure the water temperature using a sensor – thermocouple – placed in the cooling system. All AiM thermocouples are K type sensor.
-
![]()
M10 water/oil temperature PT100 thermoresistor
€85.00AiM car bike devices can measure and sample water and oil temperature using a sensor (thermoresistor) placed in the cooling system or in the oil cup.
Cable length 40 cm
PLEASE NOTE - Not suitable for Karting application. For Kart is available the following sensor:
More Info
The thermo resistor must be placed in the cooling system. It is recommended to install the sensor far from heat and electromagnetic interference sources (like RPM cable or lap receiver cables).Use the optional M10 water fitting for sensor installation:
-
![]()
M10 water temperature thermoresistor
€85.00AiM devices can measure and sample water temperature using a sensor (thermo resistor) placed in the cooling system.
