LCU Series

The Lambda controllers smaller, lighter and faster.

LCU Series is proposed in two version, AiM Expansion or Open version to be connected to every device.

LCU1S
LCU1S Open
LCU2
LCU2 Open
Sensor Compatibility
Bosch LSU 4.9
Power supply voltage
9÷15 V
Power supply current
50 mA + sensor heater typical current 750 mA up to 2 A on cold sensor
for each sensor connected
Lambda value
from 0.75
Reaction time
Less than 10 msec
Connections
6 pins Bosch female connector + 5 pins Binder 712 male connector
6 pins Bosch female connector + 7 pins Binder 712 female connector
Two 6 pins Bosch female connectors + 5 pins Binder 712 male connector
Two 6 pins Bosch female connectors + 7 pins Binder 712 female connector
Materials
Latigloss 57 (PPA Glass Fiber Reinforced)
Dimensions
43.4 x 30 x 18.4 mm
65.0 x 34.8 x 18.4 mm
Weight
70 g
Waterproof
IP67

LCU Lambda Controller series,
precision and reliability

LCU Lambda Controller Series allows you to perfectly tune your engine’s carburetion, keeping it at its best and improving performance.

The controllers can detect accurate Lambda value from 0.65 to 1.6, offering an extremely precise measurement, very useful for engine tuning. Through the analysis of the remaining oxygen, the controllers points out a possible oxygen excess/lack in the carburetion and provide essential information for 2 strokes and 4 strokes engines.
The configuration of Stoichiometric ratio allows
 LCU Series to be used on petrol, diesel and also alternative fuel powered engines.

The LCU2 versions featuring two sensors are ideal for V-type and inline engine with dual exhaust manifold configurations.

LCU series allow precise monitoring of air-fuel ratios through wideband Bosch LSU 4.9 sensors, providing accurate combustion data to optimize the power curve and improve engine tuning. Reliable Lambda data help prevent engine damage and ensure optimal performance under all operating conditions.

In fact, Bosch LSU 4.9 probe has been designed to last for more than 100,000 km on a stock car.

OPEN VERSION

LCU Open versions allow you to transmit the data via CAN to every system: configuring the output is very flexible, by setting IDs, messages, baud rate and frequency.

LCU Open versions can also be used as an AiM Expansion, without any issues or limitations.

CAN OUTPUT

LCU Open versions allows to build a CAN Output on RaceStudio 3 to communicate with external devices. You can set bit rate protocol, field messages and CAN payload details.

With the Lambda Multiplier Manager it is possible to customize the stoichiometric air fuel-ratio or choose to use the pre-defined default value.

Choose your version

LCU1S Open

Open version

LCU1S

Expansion version

LCU2 Open

Open version

LCU2

Expansion version

SPARE PARTS - OPTIONAL