Sensors

AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with

different diameters with a binder 3 pins connector with a 40 cm cable length.

More Info

AiM devices can measure exhaust gas temperature using a sensor – thermocouple – placed in the exhaust header pipe. All AiM thermocouples are K type sensor and fit car/bike/kart installations.

The version with T12 connector is CIK-FIA homologated dedicated to karting.

M5

T12

Place the exhaust gas temperature sensor (EGT) in the header pipe at about 150 mm (5.9 inches) from the exhaust pipe. Cable lenght 40 cm.

AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with

different diameters and a mignon connector with a 40 cm cable length.

More Info

The patch cable designed for MyChron6 allow the connections of different sensors.

It is available in two versions for using with thermocouples and thermoresistors.

Cable length is 150 cm, may vary depending on the connector.

More Info

The split patch cable designed for MyChron6 2T grant the use of two different sensor simultaneously.

It is available in three versions for using with thermocouples, thermoresistors or both.

Cable length is 150 cm, may vary depending on the connector.

More Info

ECLIPSE, the new line of AiM potentiometers is born; thanks to our experience in the motorsport world this new series of sensors perfectly fits the needs of the car-bike racing industry. Easy to install, our linear position sensors offer great performances in terms of accuracy, repeatability and life expectancy.

The accelerator/brake pedal position sensors represent a key support for kart drivers. They provide a precise indication of timing and intensity of braking/ acceleration. Which permits to understand if the driver has accelerated or braked at the right moment and with the correct strength. Data can be acquired by MyChron6 connected to ACC3. and analyzed on your PC. Made in anodized aluminium, these sensors are very robust. They are water-resistant, too. Even calibration is immediate. Once installed, connect the sensors to ACC3. and get pedal positions (in high position and zero position): after that the sensor will start getting acceleration/braking data.

In the box:
1 sensor, 100 cm adapter cable for ACC3, bracket kit. 

AiM devices can measure the water temperature using a sensor – thermocouple – placed in the cooling system. All AiM thermocouples are K type sensor.

More Info

AiM car bike devices can measure and sample water and oil temperature using a sensor (thermoresistor) placed in the cooling system or in the oil cup.

Cable length 40 cm

PLEASE NOTE - Not suitable for Karting application. For Kart is available the following sensor:

Kart thermoresistor

More Info

The thermo resistor must be placed in the cooling system. It is recommended to install the sensor far from heat and electromagnetic interference sources (like RPM cable or lap receiver cables).

Use the optional M10 water fitting for sensor installation:

M10 water fitting

AiM devices can measure and sample water temperature using a sensor (thermo resistor) placed in the cooling system.

More Info

Replacement temperature sensor (1 pcs - single sensor) for Tire temperature sensor kit.

A complete kit for your MyChron: thanks to the ACC3 and the split harness, it easily detects your kart’s tire temperature.