Filter By
New products
New products
Products
Discover AiM products for motorsport: lap timers, loggers, visors, steering wheels, motorsport cameras and all products properly designed and developed for your car, bike or kart.
Subcategories
-
![]()
GPS09c Open
GPS09c Open is a stand-alone device that can stream, in completely configurable messages, all the GPS data at 25 Hz via CAN or RS232.
The Pro Open version features also a 100 Hz 6 axis IMU.
Vehicle with carbon fiber roof or reduced glass surface may limit the GPS signal: the Roof version of AiM GPS09c Open is specifically designed to mount on roof of the vehicle. -
![]()
- New
LCU1S Open
LCU1S Open is a stand-alone device that allows to perfectly tune the carburetion of your engine to keeping it at its best and improve the engine's performances. lt uses a wide band Bosch LSU 4.9 sensor that saves the original calibration for the duration of the sensor's life. In fact, Bosch LSU 4.9 probe has been designed to last for more than 100,000 km on a stock car.
-
![]()
- New
ACC3 Open
ACC3 Open is the compact Analog CAN Converter by AiM
The device manages 4 analog inputs to a max frequency of 200 Hz each and thanks to the dedicated split harness, the managed inputs are: thermocouples, thermoresistances, 0-5 V Signal, 0-12 V Signal, 0-12 V Signal, 2 Digital speed inputs
ACC3 Open is freely configurable through "Open USB harness", using the AiM software RaceStudio 3.
NOTICE - "Open USB harness" sold separately. -
![]()
M10 water temperature thermoresistor
AiM devices can measure and sample water temperature using a sensor (thermo resistor) placed in the cooling system.
-
![]()
- New
M10 water/oil temperature PT100 thermoresistor
AiM car bike devices can measure and sample water and oil temperature using a sensor (thermoresistor) placed in the cooling system or in the oil cup.
PLEASE NOTE - Not suitable for Karting application. For Kart is available the following sensor:
-
![]()
M10 water temperature thermocouple
AiM devices can measure the water temperature using a sensor – thermocouple – placed in the cooling system. All AiM thermocouples are K type sensor.
-
![]()
GT32 Standalone
GT32 Standalone steering wheel transmits in a freely configurable CAN connection the status of 8 pushbuttons and 3 rotary switches plus more 2 pushbuttons in free contacts connections.
GT32 Standalone can be connected via CAN to every ECU and masters.
It features also 2 carbon fiber paddle shifters with a precise magnetic system.
The Steering wheel can be easily configured with RaceStudio 3 software via PC through USB 2.0 A-Type C-Type 200 cm cable included.
Icons set included:
-
CHT - Cylinder Head Thermocouple Binder
AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with
different diameters with a binder 3 pins connector with a 40 cm cable length.
-
CHT - Cylinder Head Thermocouple Mignon
AiM devices can measure cylinder head temperature using a sensor – thermocouple – located between the spark plug and the cylinder head. This thermocouple is available with
different diameters and a mignon connector with a 40 cm cable length.
-
![]()
K8 Open Keypad
K8 Open is a compact keypad based on CAN-bus protocol.
It can be connected through CAN to every external device.
The keypad is water and dust resistant, and can be installed both inside and outside the cockpit.
K8 Open Keypad is freely configurable through USB, using the AiM software RaceStudio 3.
